Salahudeen, A. B.
Department of Civil Engineering, University of Jos, Jos. Nigeria
Eberemu, A. O.
Department of Civil Engineering, Ahmadu Bello University, Zaria. Nigeria
Ijimdiya, T. S.
Department of Civil Engineering, Ahmadu Bello University, Zaria. Nigeria
Osinubi, K. J.
Department of Civil Engineering, Ahmadu Bello University, Zaria. Nigeria
ABSTRACT
Standard penetration test (SPT) results obtained from the
six geo-political zones of Nigeria were used to correlate soil properties and
evaluate foundation bearing capacity and settlement characteristics using some
conventional empirical/analytical models and numerical modelling. The SPT
N-values were corrected to the standard average energy of 60 % (N60)
before the soil properties were evaluated. Prediction of soil properties was
carried out for 100 kN/m2 applied foundation pressure at nine
footing embedment depths (i.e., 0.6,
2.1, 3.6, 5.1, 6.6, 8.1, 9.6, 11.1 and 12.6 m). Numerical analysis using Plaxis 3D, a finite element code, showed
that the analytical/empirical methods for estimating allowable bearing pressure
and settlement of shallow foundations gave acceptable results. Also, the
results obtained show that the susceptibility of soils in Nigeria to
compression is highest in the South - South (SS) geo-political zone and
decreased in the order South - West (SW), South - East (SE), North - East (NE),
North - West (NW) and North - Central (NC).
Average bearing capacity values in the ranges 150
– 350, 130 – 260, 135 – 310, 135 – 260, 100 – 200 and 120 – 230 kN/m2
, were determined at embedment depths in the range 0.6 - 3.6 m for NC, NE, NW,
SE, SS and SW geopolitical zones, respectively. The bearing capacity values can be used as first
approximation of foundation bearing capacity but do not preclude the use of
site specific data.
Keywords: Bearing capacity, Foundation, Numerical modelling, Plaxis 3D, Settlement, Standard penetration test
|
View: 273 | Download: 7
Published
Thursday, December 27, 2018
Issue
Vol. 4 No. 2, DEC 2018
Article Section
GENERAL
The contents of the articles are the sole opinion of the author(s) and not of UJET.
|